|
Post by FAST Racing on Oct 11, 2006 13:47:14 GMT -6
I've heard some disscussion about "needle axles"
Could someone explain and or show a photo of needle axles.
What are the adantages/drawbacks??
I need some "Ed-a-ma-kay-shun" (That's Redneck for knowledge)
|
|
|
Post by builderjim on Oct 11, 2006 13:50:18 GMT -6
|
|
|
Post by FAST Racing on Oct 11, 2006 14:56:01 GMT -6
Thanks builderjim,
Do the wheel bores need to be resized to compliment the smaller diameter of the axle?
Are needle axles a byproduct of liquid lubes (NYOIL,KRYTOX ect)?
|
|
|
Post by builderjim on Oct 11, 2006 14:59:38 GMT -6
YES is the answer to the first question if you don't purchase the RSN or the SSN wheels.
No is the answer to the second question. Must have been good engineering.
Jim
|
|
hotrod
Head in the Pine
Posts: 136
|
Post by hotrod on Oct 11, 2006 15:24:31 GMT -6
are the ssn wheels available? and where can one purchase them? I have not seen them on Max vel., derbychamp or pinewood extreme sites. thanks
Ed Half Moon Racing
|
|
|
Post by builderjim on Oct 11, 2006 15:27:58 GMT -6
|
|
|
Post by MaxV on Oct 12, 2006 7:33:06 GMT -6
|
|
|
Post by builderjim on Oct 12, 2006 7:40:07 GMT -6
Randy,
he was looking at the SSN wheels not RSN wheels. Did you miss putting them on your site?
Jim
|
|
j2ce
Addicted to Speed
Posts: 92
|
Post by j2ce on Oct 20, 2006 12:15:14 GMT -6
Randy and Jim,
I'm working on my car for the December Wirl Races. Will there be any need to do any additional preparation to the axles & wheels or can I go straight to lubing them.
j2ce
|
|
|
Post by builderjim on Oct 20, 2006 12:26:33 GMT -6
j2CE,
You will have to ask the guys who have used them 'cause i have yet to use them.
Jim
|
|
j2ce
Addicted to Speed
Posts: 92
|
Post by j2ce on Oct 20, 2006 14:07:18 GMT -6
Thanks for the reply Jim
|
|
|
Post by parrish on Oct 21, 2006 0:16:40 GMT -6
...Will there be any need to do any additional preparation to the axles & wheels or can I go straight to lubing them. j2ce I would chuck up on them high and knock off the burrs with a file and then wet polish with a fine grit paper. Good luck in December! Mike
|
|
j2ce
Addicted to Speed
Posts: 92
|
Post by j2ce on Nov 2, 2006 15:28:36 GMT -6
Thanks Mike
|
|
|
Post by FAST Racing on Nov 3, 2006 21:19:50 GMT -6
Whats the best method for resizing the bores for needle axles? 5 minute epoxy,Devcon, 10megawatt plasma blaster.... Is resizing with the above considered "bushing"
|
|