|
|
Post by PinewoodONE on Jun 8, 2004 22:35:18 GMT -6
If you don't use graphite and you go with nyoil2 after the race how do you guys remove it? Or do you? If I strip and relube the wheels and axles will it be too much?
|
|
|
|
Post by PinewoodPerformance on Jun 9, 2004 10:52:03 GMT -6
I talked to a friend of mine who has done a lot of testing with nyoil2 and he said to relube just remove, wipe down, take a dry pipe cleaner and clean out the wheel, then re-apply as normal...
|
|
|
|
Post by JohnNC on Jun 9, 2004 17:14:23 GMT -6
Just a note of caution, BE SURE TO RELUBE! There was a months delay between our Pack and Districts this year. We did not relube as we only had about 40 runs after Pack races on the wheels and lubed with NyOil II. BIG MISTAKE!
Either the lube wore/burned off, or the lube gunked up. In any case we ended up being over .1 second slower - and at Districts that is a major, major difference.
I know sometimes we don't want to remove wheels and perhaps mess up a great alignment. But if you want to be safe (with over 20 runs or three or four weeks of inactivity) I would definitely clean (denatured alcohol works great) and relube.
|
|
