|
Post by sporty on Dec 9, 2008 22:36:17 GMT -6
I have been canting my axles for a couple of years now.
I never really measured my bend on the axles.
But for those who do cant the axles.
How far have you bent the axles ? And still had great results.
If I had to take a good quess, i would say my axle cant is somewhere from the following example.
If you placed the axle on a table and the head was off the table.
The gap would be somewhere from 1/16 of a inch to 1/8th's of a inch. but certainly not less than 1/16th of a inch.
So, to the pro's, I need some real info here.
What you run for cant ! max cant or min cant.
I do not rail ride.
if you care not to share out in the open, please pm me.
I'm trying to figure out, if i am canting to much or not enough !
sporty
|
|
|
Post by ohsofast on Dec 10, 2008 7:14:55 GMT -6
I would have to believe this why Derby Worx came up with the new tool and believe me there is no more guessing it works perfectly. 1.5deg or 2.5deg. We have been working with the smaller in the front and bigger in the rear with exxellent results.
Good Luck
Terry
|
|