|
|
Post by markkaye on Nov 23, 2009 7:17:30 GMT -6
Hi to all, I have a question. Last year my son took the district. The car design was not much different from previous years but this year we dominated the pack and district. The car ran a total of 14 races. Six on an aluminum track and 8 on a fairly new wooden track. My question is can I reuse these wheels and axles as I think that must have been the winning edge for us Thanks Mark
|
|
Sappington R
Head in the Pine
"The Sappster" 10oz
Posts: 210
|
Post by Sappington R on Nov 23, 2009 9:31:44 GMT -6
Mark, I would check with your district and pack rules. The rules that we follow in our district state that the car must be built after September 1st 2009. In addition, the BSA wheels have changed for 2009-2010 (new manufacturer). It also depends upon whether you are going to do your own wheel mod's or purchase them. Many districts allow the purchasing of machined wheels. Some districts are very strict. Read your rules carefully. You may want to post them here for others to see.
Good Luck Building- Welcome to the message board.
Sapp
|
|
|
|
Post by markkaye on Nov 23, 2009 18:22:14 GMT -6
I think I will be ok with the rules. We are going to build a new car. My concern was how many runs before axles and wheels slow down? Thanks Mark
|
|
