|
Post by majorbucksarge on Jan 15, 2010 2:55:17 GMT -6
I am in Indian Guides and have a racer from S&W-the site is pinewoodderbycars.com. I just received a hub tool and a pro wheel shaver from Derby Worx and nothing fits. The wheels are not BSA and not sure what to do. The race is this Sunday and I need some help please. Derby Worx mentioned a 1/8" brass tubing that was not included, can anyone help quick?
Ken
|
|
|
Post by majorbucksarge on Jan 15, 2010 9:48:17 GMT -6
can anyone help?
|
|
|
Post by Lucky 13 on Jan 15, 2010 10:23:48 GMT -6
I am in Indian Guides and have a racer from S&W-the site is pinewoodderbycars.com. I just received a hub tool and a pro wheel shaver from Derby Worx and nothing fits. The wheels are not BSA and not sure what to do. The race is this Sunday and I need some help please. Derby Worx mentioned a 1/8" brass tubing that was not included, can anyone help quick? Ken Ken, The S&W kits use a wheel that is basically like the original BSA wheel. The Derby Worx website gives these instruction to make the wheel shaver compatible with the S&W wheels.... Instead of using the Pro Hub Tool to ream the bores. Derby Worx says.. Royal Ranger and S&W Kits Only - Ream the wheel bores by hand with a 1/8" drill bit.To be able to use the Wheel Shaver on the S&W wheels. You will need to pick up a piece of 1/8 brass tubing that will fit over the hub tool. Royal Ranger and S&W kit wheels only - Slide a short piece of 1/8" brass tubing over the pin of the Pro-Hub Tool. From there, the instructions are the same as any wheel. Just stop at a local hardware store. You should be able to find a small length of tubing to sleeve the wheel bore down so the hub tool will work and then you should be in business. Lucky 13
|
|
|
Post by MaxV on Jan 15, 2010 13:54:03 GMT -6
|
|