|
Post by 3171scott on Dec 19, 2012 18:26:11 GMT -6
I purchased the pro hub tool last year. I have a very difficult time inserting a wheel on to it. It takes a great amount of pressure and twisting to get the wheel on and when its on you cant spin it. I also ordered the wheel shaver XT and had a very difficult time using the tools together. I watched all the you tube videos and mine don’t work that well. I even chucked it in a drill press and used 800 grit paper to sand it down. I don’t have the means to accurately turn down the shaft, so I did not want to go to far. Also I don’t think I should have to do this to a tool that is supposed to be a “Pro Tool”. Did I get a bad one? What diameter is the shaft to be? It doesn’t make a difference what side I use. I have tried about 8 to 10 sets of wheels and they are all about the same so im pretty sure that it’s the tool.
Pleas give some incite!
Thanks Scott
|
|
|
Post by RacerX on Dec 20, 2012 9:19:08 GMT -6
Scott,
This sounds like you might have a bad tool, e-mail me your info and we will get you taken care of right away.
Racerx@Derbyworx.com
Thanks
Racer X
|
|
|
Post by 3171scott on Dec 24, 2012 11:18:40 GMT -6
Thanks Racer X! Love the support from this place!
|
|